The 'Rolls Royce' of mounting plates they offer a good range of integral cam-action vertical adjustment and simple snap-on fitting of the hinge arm.
These plates are suitable for hinge series 200, ...
A good quality diecast Mount Plates. They offer a good range of integral cam-action vertical adjustment. Hinge Arm slides on and is screwed tight. These plates are suitable for hinge series 200, 40...
This version is fitted with pre-mounted Euro screws for installation on cabinets with pre-drilled 5mm diameter holes on 32mm pitch centres.
Screw holes to be drilled 37mm from edge of the carcase....
This budget pressed steel Mount Plate range does not offer any vertical adjustment to the hinge
other than the eliptic fixing slot.
Suitable for hinge ranges 200, 400, 700, 900, F & M.
Requir...
This budget pressed steel Mount Plate range does not offer any vertical adjustment to the hinge other than the eliptic fixing slot. Pre-mounted EURO fixing screws for pre-drilled 5mm diameter holes...
A diecast variable angle mount plate.
Gives +/- 7.5 degrees of angle adjustment, ideal for cabinet doors with unusual shallow angles, backwards or forwards,
A diecast variable angle mount plate.
Suitable for doors with postive angle in the range 10 degrees to 30 degrees. Often used on cupboards with curved cabinet doors.
The basic pressed steel clip-on Mount Plate of the DOMI snap-on system.
Hight adjustment is by elongated screw holes, requiring the fixing screws to be slackened off and then retightened.
These p...
A tall diecast mount plate for use on 'face-frame' or 'in-frame' cabinets. 'DOMI' clip-on pattern for easy door mounting.
24mm effective height. Supplied with pre-fttted EURO screws for installti...
The 'Rolls Royce' of mounting plates they offer a good range of integral cam-action vertical adjustment and simple snap-on fitting of the hinge arm. Featuring a euro screw (5mm diameter) fitting.
T...
A diecast straight 'DOMI' Mount Plate for use with standard wood screws (3.5 x 16mm), finished with Salice's new TITANIUM colour.
Front screw hole to be drilled 21mm from edge of carcase.
0mm or ...
A tall Diecast mount plate for use on 'face-frame' or 'in-frame' cabinets.
20.5mm effective height. Supplied with pre-fitted EURO screws for installation in pre-drilled 5mm holes.
To be used in c...
A pressed steel mounting plate with pre-mounted 5mm euro fixing screws, with additional rear fixing hole (screw not supplied).
Only available in 3mm height.
This mount plate will suit all Salice hi...
